Configuration - SolarEdge Immersion Heater Controller Installationshandbuch

Configuration

Configuration
NOTE
Verify that the inverter is connected to the monitoring portal (refer to the Inverter Installation Guide for
details on setting up communication).
To associate the device with the ZigBee network:
1. Enter the inverter Setup mode as described in the Inverter Installation Guide.
2. Select Communication è ZigBee Conf..
3. Select:
Device Typeè HA (Home Automation)
l
Protocol è HAM (Home Automation)
l
D e v i c e
P r o t o c o l < H A M >
P A N I D
S c a n
L o a d
When HA Device Type is selected, a Device Manager menu item will appear in the main configuration
menu:
C o u n t r y
L a n g u a g e
C o m m u n i c a t i o n
P o w e r
D i s p l a y
M a i n t e n a n c e
I n f o r m a t i o n
4. From the main menu select Device Manager. The Device Manager screen is displayed:
A d d D e v i c e s
5. Select Add Devices to start the device association with the inverter.
6
SolarEdge Immersion Heater Controller Installation Guide MAN-01-00279-1.3
T y p e < H A >
C h a n n e l
Z B D e f a u l t s
< I t a l y >
< E n g >
C o n t r o l
< 0 >