Specifications; Additional Safety Rules - Makita GD0600 Bedienungsanleitung

ENGLISH
1-1. Switch lever
1-2. Lock-off lever
1-3. Lock button

SPECIFICATIONS

Max. collet capacity
Max. wheel point diameter
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 73 dB (A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN50144.
For Model GD0600
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN50144, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2006
000087
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
Explanation of general view
2-1. Wrench 13
2-2. Collet nut
2-3. Wrench 13
Model
-1
)
Overall length
Net weight
Safety class
2
.
Director
ENE050-1
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
ENF002-1

ADDITIONAL SAFETY RULES

1. Always use eye and ear protection. Other
personal protective equipment such as dust
mask, gloves, helmet and apron should be
worn.
2. Use only wheels with the correct size and
wheels having a maximum operating speed at
ENG019-1
least as high as the highest No Load Speed
marked on the tool's nameplate.
3. Check the wheel carefully for cracks or
damage before operation. Replace cracked or
damaged wheel immediately.
4. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
5. Before using the tool on an actual workpiece,
test run the tool at the highest no load speed
for at least 30 seconds in a safe position. Stop
immediately if there is any vibration or
wobbling that could indicate poor installation
ENH001-6
or a poorly balanced wheel. Check the tool to
determine the cause.
6. Check
supported.
7. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
8. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
9. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
3
4-1. Side handle
GD0600
6 mm or 6.35 mm (1/4")
38 mm
25,000
358 mm
1.6 kg
/II
that the workpiece
ENB044-3
is properly