Makita GD0600 Bedienungsanleitung Seite 5

ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Side handle
Fig.4
When using the side handle, remove the rubber
protector, insert the side handle on the tool barrel as far
as it will go and rotate it to the desired angle. Then
tighten the handle firmly by turning clockwise.
CAUTION:
When using the tool without handle, always install
•
the rubber protector on the tool.
When installing the rubber protector, always push it
•
onto the tool until the protrusion inside the rubber
fits to the grooves in the tool.
Wheel points
•
Collet cone set (3 mm, 6 mm, 1/4", 1/8")
•
Wrench 13
•
Side handle set
•
Vise holder
•
or attachments
Only use accessory or
are
5