Items Supplied; Unpacking; Assemble Appliance; Operation - Silvercrest STV 50 A1 Bedienungsanleitung

WARNING! Risk of material
damage
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 tower fan 1
1 base (consisting of 2 parts) 8
1 knob screw 13
2 crosshead screws
1 set of operating instructions

Unpacking

1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.

5. Assemble appliance

Before the device can be used, the base 8
must be screwed on:
1. Figure A: put the rear half of the
base 10 and the front half of the
base 11 together. Ensure that the con-
nection audibly clicks into place. Fix
the two halves from below using the
supplied crosshead screws.
NOTES:
• The rear half of the base 10 can be
identified by the recess for the mains
power cable 9.
• Ensure that the mains power cable 12 is
lying in the recess for the mains power ca-
ble 9.
2. Figure B: fully unscrew the knob
screw 13 at the bottom of the fan.
Press the mains power cable 12 into
the recess for the mains power cable 9
in the base 8 and mount the base on
the tower fan 1.
3. Fix the base 8 and the tower fan 1 to-
gether using the supplied knob
screw 13. Place the tower fan 1 on its
base 8 and ensure it is standing in a
stable location.
4. Select a location which complies with
the safety instructions (see "Safety infor-
mation" on page 3).
5. Insert the mains plug 12 into a mains
socket corresponding to the technical
data.

6. Operation

6.1 Start and switch off the
appliance
1. Plug the power plug into a power sup-
ply socket which meets the technical
data requirements.
2. Switch on the power
supply by turning rota-
ry switch 6 to ON.
The appliance is now
operational.
3. Switch off the power
supply by turning rota-
ry switch 6 to OFF.
6.2

Set blower setting

The blower settings are used to select how
fast the appliance circulates air in the room.
The appliance has three blower settings:
- 1, low: press button 7;
- 2, moderate: press button 5;
- 3, high: press button 4.
Press the 2 OFF button to stop the appliance
working.
5
GB