Items Supplied; Unpacking; Assemble Appliance; Operation - Silvercrest STV 45 C2 Bedienungsanleitung

__CPE273374 Tower Ventilator_B7.book Seite 5 Dienstag, 13. Oktober 2015 10:00 10
WARNING! Risk of material
damage
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Only use the original accessories.
~ Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 tower fan|1
1 stand (consisting of 2 parts)|8
1 screw ring (screwed to the underside of
the fan)|12
1 set of operating instructions

Unpacking

1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.

5. Assemble appliance

Before the appliance can be started up,
stand|8 needs to be screwed on.
1. Put rear half of the stand|10 and front
half of the stand|11 together.
NOTE: You can recognize rear half of the
stand|10 by the depression for power sup-
ply cable|9.
2. Use screw ring|12 supplied to screw
stand|8 to the underside of the tower
fan.
NOTES:
• On delivery, screw ring|12 is screwed
onto the bottom of the tower fan.
• Ensure that power supply cable|9 is lo-
cated in the depression provided for it.
• Tighten screw ring|12 hand-tight. Do
not use a tool.
3. Select a location in line with the safety
instructions (see "Safety information"
on page 3).
4. Plug the power plug into a power sup-
ply socket which meets the technical
data requirements.

6. Operation

6.1 Start and switch off the
appliance
1. Plug the power plug into a power sup-
ply socket which meets the technical
data requirements.
2. Switch on the power
supply by turning rota-
ry switch|2 to "ON".
The appliance is now
operational.
3. Switch off the power
supply by turning rota-
ry switch|2 to "OFF".
5
GB