Mounting An Internal Dat Drive; Mounting Holes For Internal Dat Drive In 3.5-Inch Configuration (No Mounting Brackets); Side View; Bottom View - Seagate DDS Installationsanleitung

Seagate DAT Drive Installation Manual—English

Mounting an internal DAT drive

You can install your Seagate internal DAT drive horizontally
or vertically (on its side).
Mounting the drive in a 3.5-inch drive bay
To mount the drive in a 3.5-inch drive bay, mount the drive
using two M3.0 metric screws on each side of the drive. Do
not use screws longer than 4 mm or you may damage the
drive. As shown in Figure 4, the 3.5-inch drive has four screw
holes on the bottom and five on each side.
Figure 4
Mounting holes for internal DAT drive in 3.5-inch
configuration (no mounting brackets)
41.3 mm
(1.63 in)
28.3 mm
(1.11 in)
2 PLACES
35.0 mm
(1.38 in)
2 PLACES
M3.0 X
4 DEEP MIN.
10 PLACES
6 mm
(.24 in)
2 PLACES
41.2 mm
(1.62 in)

Side View

3.8 mm
8.0 mm
(.15 in)
(.31 in)
2 PLACES
2 PLACES
5.0 mm
(.20 in)
2 PLACES
30.0 mm
(1.18 in)
2 PLACES
152 mm
(5.98 in)
60.0 mm
(2.36 in)
2 PLACES
21.0 mm
(.83 in)
2 PLACES

Bottom View

A-13
101.6 mm
(4.00 in)
94.0 mm
(3.70 in)
45.0 mm
(1.77 in)
M3.0 X
4 DEEP MIN.
4 PLACES
70.0 mm
(2.76 in)
31.0 mm
(1.22 in)
104.1 mm
(4.10 in)