Mounting An Internal Dat Drive; Connecting Power And Interface Cables - Seagate std224000n Installationsanleitung

Seagate DAT Drive Installation Manual

Mounting an internal DAT drive

You can install your Seagate internal DAT drive
horizontally or on its side.
Mount the drive using two M3.0 metric screws on each
side of the drive. Do not use screws longer than 4 mm or
you may damage the drive. The 3.5-inch drive has four
screw holes on the bottom and five on each side. The 5.25-
inch drive has four screw holes on the bottom and six on
each side.

Connecting power and interface cables

Attach the power and SCSI interface cables to the
connectors on the back of the drive. Figure 4 on page 7
shows the locations of these connections for the 3.5-inch
drives, and Figure 5 on page 8 shows these connections for
the 5.25-inch drives.
Note. Turn off all power before inserting connectors.
Pin 1 on the SCSI connector is to your right as you
look at the back of the drive (see Figure 4 or 5). Your
SCSI cable should have pin 1 highlighted by a colored
stripe. Be sure to align pin 1 on the cable with pin 1
on the drive, or the drive may not work.
The recommended power mating connector for this drive
is an AMP 1-48024-0 housing with AMP 60617-1 pins or
equivalent.
10