Configuring For The Hp-Ux Workstation Environment - Seagate DDS Installationsanleitung

Seagate DAT Drive Installation Manual—English
String before making the changes outlined above. This is
done using the mt command. The following example with
retrieve the Inquiry string and other status data from a Drive
on SCSI bus 1, ID 4.
mt -f /dev/rmt/tps1d4 status
System Interchange Problems.
If the following error appears when trying to restore a cpio
archive from another system, it is likely a mistake has been
made in the installation sequence above:
Byte swapped Data - re-try with correct device
If this error is encountered, it is probably caused by incorrect
setup, as described above, Check and verify the correct
modifications were made to /var/sysgen/master.d/scsi.
Switching Hardware Compression.
Support for switching Hardware Compression is supported in
Irix 6.x via the use of different device drivers. Drivers
including a "c" in the device name should enable
compression. problems seen with compressed operation
were resolved by installing the latest Irix 6.x patch set.

Configuring for the HP-UX Workstation Environment

HP-UX Version 10.2 and later
1. Log in as root
2. Run the SAM utility
3. Choose the Peripheral Devices option
4. Choose Tape Drives
5. From the Actions menu in the Tape Device Manager
window, choose Add
6. Within the Add a Tape Drive window, read the
instructions, then click on OK.
A-35