I/O Port; Pin Assignment Of I/O Port Audio In/Out - Sony NSR-S10 Installationsanleitung

I/O Port

Pin Assignment of I/O Port
Audio In/Out
Pin NO. AUDIO
1 AUDIO IN
2 AUDIO IN GND
3 AUDIO OUT
4 AUDIO OUT GND
Caution
AUDIO IN is intended for future
expansions and is not currently supported.
Sensor In and Relay Out
Pin NO. SENSOR
5 SENSOR IN 1
6 SENSOR IN 1 GND
7 SENSOR IN 2
8 SENSOR IN 2 GND
9 SENSOR IN 3
10 SENSOR IN 3 GND
11 SENSOR IN 4
12 SENSOR IN 4 GND
13 RELAY OUTPUT +
14 RELAY OUTPUT –
Using the I/O Receptacle
Insert a small slotted screwdriver into the
upper or lower slot of the hole you want to
connect a wire to (AWG No. 26 to 20).
Hold down the screwdriver and insert the
wire, then release the screwdriver.
Caution
Do not use excessive force when inserting
the screwdriver into the slot. Doing so may
result in damage.
1
2
Repeat this procedure to connect all
required wires.
Wiring Diagram for Audio
Output
Inside of this unit
220 μF
Audio
47 kΩ
Codec
Wiring Diagram for Sensor
Input
Inside of this unit
Vcc = 5 V
200 Ω
Sensor In 1, 2, 3, 4
Sensor In 1G, 2G, 3G, 4G
3
Outside
Example)
Headphone
RL=16 Ω/32 Ω
Outside
(Example)
I/O Port 21