User Interface And Navigation - Hach CD300 Benutzerhandbuch

Table 7 Wiring information—Analog outputs and external trigger (CON2)
Pin
1
2
3
4

User interface and navigation

Display overview
Do not use writing tips of pens or pencils or other sharp objects to make selections on the screen or damage to
the screen will occur.
Use fingers or a touch screen pen to operate the touch screen of the CD300 controller. The main
screen and the control elements can be configured individually.
Note: Do the CD300 configuration settings in Service mode only.
Figure 8 Display overview
1 Date and time
2 Current mode
Icon Description
Shows the left and right COM ports and sensors. To change the settings, push the COM button. To
search for a sensor, push Scan.
Shows the different pages.
To change the page, sweep to the side.
To edit a page, push the display to get a yellow frame.
To add a new page, push the display for three seconds.
Refer to the user manual.
N O T I C E
3 Navigation bar (refer to
Table 8 Navigation bar description
Description
Output 1 +
Output 1 – GND
Output 2 +
Output 2 – GND
Table 8)
English 19