Maunfeld MLP 12S Bedienungsanleitung Seite 88

DISHWASHER INSTALLATION
RECOMMENDATION FOR CONNECTION
COLD WATER CONNECTION
Connect the cold water supply hose with the ³/₄ inch adapter and make sure
that it is tight. If the water supply pipes are new or have not been used for a
long time, let the water drain to make sure that the water is clean and free of
impurities. If you do not follow these instructions, the inlet valve may become
clogged, causing a breakdown in the machine.
HOT WATER CONNECTION
Hot tap water can also be used for the machine operation, but only if its
temperature does not exceed 60 °C. In this case, the washing cycle will be
reduced by about 15 minutes, and the washing efficiency will slightly decrease.
Hot water connection should be done in the same way as with cold water.
APPLIANCE LOCATION
Install the machine in the selected location. The back wall of the appliance
should rest against the wall, and the left and right walls should bear against
the walls of the cupboard. The dishwasher is equipped with drain and filling
hoses, which should be placed to the right and left of the machine in order to
install the machine properly.
DRAIN HOSE CONNECTION
Connect the drain hose. The drain hose must be properly installed to avoid
water leaks. Make sure that there is no bending of the drain hose and nothing
is squeezing it. The drain hole must be 40 cm (minimum) and 100 cm
(maximum) from the floor. The end of the drain hose must be secured at the
drain with a special hose clamp and must not be immersed in water.
-24-
www.maunfeld.com