Earthing Instructions; Gas Supply Requirements - Whirlpool 3LCGD9100 Bersetzung Der Original Bedienungsanleitung

This dryer is supplied/fitted with an electricity supply cord and plug. It
should be connected to electricity supply socket at the voltage shown
on the rating plate. The minimum supply fuse capacity should be 5A.
The dryer must be positioned so that the plug is clearly visible and
accessible. This plug also provides the function of an emergency stop
control for the user. If the fitted plug is not used, the electrical connection
must be carried out by a competent electrician in accordance with local
or national codes.
If the supply cord is damaged, it must be replaced with a specially
terminated cord by an authorized service agent or a similarly competent
person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive (2004/108/EC),
the maximum electricity supply system impedance to which the gas
dryer should be connected is declared to be 0.054 Ohm + j0.034 Ohm.
NOTE: Electrical safety standards: The manufacturer has chosen compliance
with IEC/EN.60335 standards as the most appropriate for this product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.

EARTHING INSTRUCTIONS

SAVE THESE INSTRUCTIONS
6
Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits
your electrical outlet, and plug it into the adapter on the
supply cord.
2. Secure the plug end in place on the cord by aligning
the 2 cover halves over the cord adapter and clipping
them together.

Gas Supply Requirements

IMPORTANT: Observe all governing codes and ordinances.
Gas Supply
Before installation, check that the local gas distribution
conditions, nature of gas and pressure, and the adjustment
of the appliance are compatible. Burner information will be
found on the model/serial rating plate in the door recess of
the dryer. If this information does not agree with the type
of gas available, see your dealer.