Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
200 mm (8") or 250 mm
I
(10") Pipe wrench
200 mm (8") or 250 mm
I
(10") Adjustable wrench
Flat-blade screwdriver
I
Phillips screwdriver
I
Adjustable wrench that
I
opens to 25 mm (1") or
hex-head socket wrench
Level
I
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
Foot boot (4)
I
Dryer foot (4)
I
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.
4
DRYER DISPOSAL
INSTALLATION REQUIREMENTS
8 mm (
5
/
) socket wrench
I
"
16
Utility knife
I
Vent clamps
I
Pipe-joint compound
I
resistant to LP gas
Sealing gun and sealing
I
compound (for installing
new exhaust vent)
Pliers
I
Stiff-bladed putty knife
I
Location Requirements
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
I Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
I Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" below
for minimum spacing requirements.
I Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.
Werbung
Inhaltsverzeichnis
