Installation; Electrical Connection - Refsta NEPTUN Gebrauchsanweisung

Installation should be carried out by qualified
personnel , in compliance with all the current
regulations and in particular with the ones
concerning air ducting and electrical connection.
The manufacturer declines all responsability in
case of damages caused by improper installation
or non in compliance with the rules of art .

INSTALLATION

Do not connect the cooker hood ducting to the same
tube used to circulate hot air or to duct fumes of
appliances generated by non-electrical source.
When operating the cooker hood simultaneously with
other non electrical supplied appliances , enough
ventilation of the room should be granted. Maximum
room depression should not exceed 4 Pa .
COOKER HOOD MOUNTING
• Minimum distance between cooker hood and
hob is 420mm . In case of gas cookers this
distance should be of 650mm.
• Drill 6 holes (A-B-C) as indicated on (Fig.3) .
• Insert the 6 dowls into the holes. Please make
sure of using the proper dowls for the wall
fixing.
• Fix the hood body to the wall using specific
screws (holes "B" & "A" Fig 3)
• Lean the telescopic chimney ("S"+"i" Fig 3)
on the upper side of the cooker hood body and
fix the lower chimney onto the cooker hood
body D Fig 3 with 2 screws ("V" Fig 3)
provided.
• Fix the chimney bracket Z into the wall holes
C Fig 3 using appropriate dowls.
• Lift the inner part of the telescopic chimney
until the desired light and fix the bracket Z with
the screws provided.
DUCTING MODE
• Connect the hood by mean of a duct to the air
outlet exhaust.
(do not follow these instruction for the recycling
mode) .
RECYCLING MODE
In order to transform your cooker hood from the ducted
to the re cycling mode , as your local dealer for
activated carbon filters and follow instruction as
indicated on (Fig.7 ) .
The air is conveyed back into the kitchen through the
eyeleds of the upper chimney.

ELECTRICAL CONNECTION

Verify the mains voltage complies with the indications
given on the technical label inside the appliance.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European Directive 2002/96/CE on Waste requires
that old electrical and electronical household appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery
and re cycling of the materials they contain , reducing
this way the impact on human health and the
environment. The crossed-out dustbin symbol on the
product reminds you of your obligation regarding
separated waste collection. Consumers should contact
their local public service or their local dealer for more
information on the correct disposal of exhausted
household appliances.
THE MANUFACTURER DECLINES ALL
RESPONSABILITY FOR ANY DAMAGE CAUSED BY
BREAKING THE ABOVE WARNINGS. THE WARRANTY
IS NOT VALID IN CASE OF DAMAGE CAUSED BY
FAILURE TO COMPLY WITH THE ABOVE WARNINGS.