Intended Use; Approvals - Dräger FS series Gebrauchsanweisung

2.3

Intended use

The flame simulators are used to test the following components and
features of flame detectors:
sensors

internal electronics

alarm activation software

cleanliness of the detector window

wiring integrity

actual relay activation

proper functionality of any other outputs used (0...20 mA, RS-485,

HART).
The flame simulators are used to check the correct function of the
following flame detectors:
Flame simulator
Dräger FS 1100
Dräger FS 1200
Dräger FS 1300
Dräger FS 1400
Flame detector
Dräger Flame 2500/2570
Dräger Flame 2100/2350/2370
Dräger Flame 2000
Dräger Flame 2700
2.4

Approvals

2.4.1 FS 1100/1400
The flame simulators are classified as follows:
Ex-approval Classification
ATEX/IECEx II 2 G/D
Ex d ib op is IIB + H
Ex ib op is tb IIIC T135 °C Db
-20 °C to +50 °C (-4 °F to +122 °F)
IP65
The flame simulators are suitable for use in hazardous zones 1 and 2,
Zones 21 and 22 with IIB + H
2
2.4.2 FS1200/1300
The flame simulators are classified as follows:
Ex-approval Classification
ATEX/IECEx II 2 G
Ex d ib op is IIB + H
-20 °C to +50 °C (-4 °F to +122 °F)
IP65
The flame simulators are suitable for use in hazardous zones 1 and 2
with IIB + H gas group vapor present.
2
Description
T5 Gb
2
gas group vapor present.
T5 Gb
2
en
7