Drawings And Dimensions - OHAUS Valor 2000 Serie Bedienungsanleitung

Valor 2000 Series Scales

7.2. Drawings and Dimensions

Figure 7-1. Valor 2000 Series Overall Dimensions.
EN-13 EN-14
7.3. Compliance
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product conforms to the EMC directive 89/336/EEC and the Low
Voltage Directive 73/23/EEC. The complete declaration of Conformity
is available from Ohaus Corporation
AS/NZS4251.1 Emission; AS/NZS4252.1 Immunity
NSF/ANSI 169 - 2005
NSF/ANSI /3-A 14159-1 - 2002
Important notice for verified weighing instruments
Weighing Instruments verified at the place of manufacture
bear one of the preceding mark on the packing label and
the green 'M' (metrology) sticker on the descriptive plate.
They may be put into service immediately.
Weighing Instruments to be verified in two stages have no
green 'M' (metrology) on the descriptive plate and bear
one of the preceding identification mark on the packing
label. The second stage of the initial verification must be
carried out by the approved service organization of the
authorized representative within the EC or by the national
weight & measures (W+M) authorities.
The first stage of the initial verification has been carried out at the manufacturers work. It
comprises all tests according to the adopted European standard EN 45501:1992,
paragraph 8.2.2.
If national regulations limit the validity period of the verification, the user of the weighing
instrument must strictly observe the re-verification period and inform the respective W+M
authorities
.
Valor 2000 Series Scales