Maintenance - Stiga TITAN Serie Gebrauchsanweisung

GB
5.4 Mowing advice
In order to achieve optimum mowing results, fol-
low the advice below:
• Cut frequently.
• Run the engine at full throttle.
• The grass should be dry.
• Use sharp blades.
• Keep the underside of the cutting deck clean.

6 MAINTENANCE

6.1 Preparation
All service and all maintenance must be carried out
on a stationary machine with the engine switched
off.
Prevent the machine from rolling by al-
ways applying the parking brake.
Stop the engine.
Prevent unintentional starting of the
engine by removing the ignition key.
6.2 Washing position
It is absolutely forbidden to start the
engine when the deck is in the cleaning
position.
1. Activate the parking brake.
2. Set the deck in the transport position.
3. Set the maximum cutting height.
4. Stop the engine
5. Remove both pins (5:A) and remove any wash-
ers.
6. Slacken off the belt tensioner and unhook the
belt from the machine's pulley. See fig. 3.
7. Set the catch (7:C) to the rear position so that it
can lock.
8. Grip the front edge of the deck and lift up until
the deck locks in the first locking position.
See fig. 8.
6.3 Service position
It is absolutely forbidden to start the
engine when the deck is in the service
position.
1. Set the deck to the cleaning position. See above.
2. Grip the front edge of the deck and lift up fur-
ther until the deck locks in the second locking
position. See fig. 9.
26
ENGLISH
6.4 Resetting
Two people are required to reset from the cleaning
and service position as follows:
1. Person 1 lifts the deck at the front edge so that
it releases from catch (7:C).
2. Person 2 sets the catch to the front position.
3. Person 1 carefully lowers the deck to the
ground.
4. Other connections are made according to the
relevant section under "3".
6.5 Cleaning
The underside of the deck must be cleaned after
each use.
Set the deck in the cleaning position.
Clean the underside of the deck thoroughly. Use
water and a brush.
When the surfaces are completely dry and clean,
touch up the paintwork. Use durable paint intended
for metal outdoors.
7 MAINTENANCE
7.1 Lubrication
Lubricate all lubrication points according to the ta-
ble below.
The three cutting shafts (11:B) must be lubricated
every 100 operating hours as well as after each
clean.
Other lubrication points must be lubricated every
250 hours of operation.
Use a grease gun, filled with universal grease for
the grease nipples. Pump until grease protrudes.
The lubrication points are shown in fig. 10.
Object
Bearing, belt ten-
sioner
Cutting shafts
Bearings, link
wheel
Bearing on right
and left sides
Lubrication nipples Figure
/ action
1 lubrication nipple 11:A
3 lubrication nipples 11:B
4 lubrication nipples 11:C
2 lubrication nipples. 11:D