Use - Auping Superbox Gebrauchsanweisung

4. Use

The infrared remote control allows you
to operate your boxspring without the
nuisance of cables. The remote
control consists of two parts:
- a handset (see fig. 17);
- a receiver located under the
boxspring.
1. Raise back section
2. Lower back section
3. Raise foot end*
4. Lower foot end*
5. Raise back section and foot end*
6. Lower back section and foot end*
Press one of the 'up' or 'down'
buttons, holding it down until the
desired position is reached. Only one
button can be operated at a time.
In order to operate two boxsprings
independently of one another in the
same room, both the handset and the
receiver must be set. Both have been
fitted with a switch for this purpose.
These are clearly recognisable, thanks
to their red colour.
The switch for the receiver is on the
outside, while that of the handset is in
the battery compartment. Ensure that
the switches on the handset and
receiver for one of the boxsprings are
both slid to one side. Those for the
other boxspring* should be slid to the
opposite side.
fig. 17
*If applicable
GB 11