Dc-Kit4/Dc-Kit6 With Dometic B3200; Dc-Kit4/Dc-Kit6 With Dometic Freshjet1100/1700/2200/2600/3200 - Waeco ECL-102 Montage- Und Bedienungsanleitung

Connection
7.11

DC-Kit4/DC-Kit6 with Dometic B3200

 Roof air conditioner: Dometic B3200
 Circuit diagram: fig. k, page 23 (12 V), fig. n, page 26 (24 V)
 Charging current distributor: ECL-102/ECL-103
 Inverter: SinePower MSI2312T/MSI2324T
➤ Install inverter remote control MCR9 in an easily-accessible place (jumper closed, refer
to remote control installation manual) and connect its cable to the inverter.
➤ Unravel the 2-wire universal connection cable (on/off cable, item no. 4441300124)
so that you have two individual wires.
➤ Use the blue wire of the universal connection cable (item no. 4441300124) to join the
I5 connection of the ECL-102/ECL-103 to the MCR9 remote control (use wire sleeves).
➤ Use the brown wire of the universal connection cable to join the D+ input to the
I2 connection on the ECL-102/ECL-103 (use wire sleeves).
7.12 DC-Kit4/DC-Kit6 with Dometic
FreshJet1100/1700/2200/2600/3200
 Roof air conditioner: Dometic FreshJet1100/1700/2200/2600/3200
 Circuit diagram: Dometic FreshJet1100/1700/2200/2600/3200:
fig. l, page 24 (12 V), fig. o, page 27 (24 V)
 Charging current distributor: ECL-102/ECL-103
 Inverter: SinePower MSI1812T/MSI1824T
➤ Install inverter remote control MCR9 in an easily-accessible place and connect its
cable to the inverter.
➤ Remove the FreshJet1100/1700/2200/2600/3200 outlet panel, if necessary remove
the upper cover.
➤ Connect the wire sleeves of the universal connection cable to contacts I5 and I2 on the
charging current distributor.
➤ Join the on/off cable of the FreshJet1100/1700/2200/2600/3200 to the plug connector
on the circuit board (fig. r, page 29 for FreshJet).
I
NOTE
Guide the on/off cable carefully past the fan.
➤ Connect both the wires on the universal connection cable (item no. 4441300124) to the
two wires on the on/off cable of the FreshJet1100/1700/2200/2600/3200.
112
ECL-76, ECL-102, ECL-103
EN