Dc-Kit1 With Dometic Ca1000 - Waeco ECL-102 Montage- Und Bedienungsanleitung

ECL-76, ECL-102, ECL-103
PerfectPower PP1002 and PP2002
➤ Join the 230 V connector of the air conditioner to the PerfectPower
PP1002/PP2002 inverter.
SinePower MSI1812T and MSI1824T
➤ Join the 230 V connector of the air conditioner to the the SinePower
MSI1812T/MSI1824T inverter.
I
NOTE
The remote controls for switching the inverters on and off must be connected
in accordance with the enclosed instructions and the relevant circuit diagram
(see pages fig. 1, page 3 to fig. o, page 27).
7.1

DC-Kit1 with Dometic CA1000

 Roof air conditioner: Dometic CA1000
 Circuit diagram: fig. 1, page 3
 Charging current distributor: ECL-76
 Inverter: PerfectPower PP1002
➤ Install inverter remote control MCR9 (membrane button) in an easily-accessible place
and connect its cable to the inverter.
I
NOTE
Observe also the instructions in the scope of delivery of the sensing cable.
➤ Remove the CA1000's outlet panel.
➤ Insert the three-pole plug of the sensing cable into the socket (3-pole pin strip socket)
on the control PCB of the air conditioner (fig. q, page 28).
➤ Link the ECL-76 to the air conditioner using the two-wire on/off cable (sensing cable,
item no. 4441300084).
➤ Set the AC/DC switching parameters for the air conditioner to "02" ( installation
manual for the CA1000, "Configuring the system software").
EN
Connection
105