Dc-Kit2 With Dometic Freshjet1100/1700/2200, Freshlight1600/2200; Dc-Kit3/Dc-Kit5 With Dometic Ca1000/Ca2500/B2200/B1600 Plus - Waeco ECL-102 Montage- Und Bedienungsanleitung

Connection
7.5 DC-Kit2 with Dometic FreshJet1100/1700/2200,
FreshLight1600/2200
 Roof air conditioner:
– Dometic FreshJet1100/1700/2200
– Dometic FreshLight1600/2200
 Circuit diagram:
– Dometic FreshJet1100/1700/2200: fig. 6, page 8
– Dometic FreshLight1600/2200: fig. 7, page 9
 Charging current distributor: ECL-102
 Inverter:
– Dometic FreshJet1100/1700/2200: SinePower MSI1812T
– Dometic FreshLight1600/2200: PerfectPower PP2002
➤ Install inverter remote control MCR9 (membrane button) in an easily-accessible place
and connect its cable to the inverter.
➤ Remove the FreshJet/FreshLight's outlet panel, if necessary remove the upper cover.
➤ Connect the wire sleeves of the universal connection cable to contacts I5 and I2 on the
charging current distributor.
➤ Join the on/off cable of the FreshJet1100/1700/2200, FreshLight1600/2200 to the plug
connector on the circuit board (fig. r, page 29 for FreshJet and fig. s, page 29 for
FreshLight).
I
NOTE
Guide the on/off cable carefully past the fan.
➤ Connect both the wires on the universal connection cable (item no. 4441300124) to the
two wires on the on/off cable of the FreshJet1100/1700/2200, FreshLight1600/2200.
7.6 DC-Kit3/DC-Kit5 with Dometic
CA1000/CA2500/B2200/B1600 Plus
 Roof air conditioner:
– CA1000/CA2500
– B1600 Plus/B2200
 Circuit diagram:
– CA1000/CA2500: fig. 8, page 10 (12 V), fig. d, page 16 (24 V)
– B1600 Plus/B2200: fig. 9, page 11 (12 V), fig. e, page 17 (24 V)
 Charging current distributor: ECL-102/ECL-103
 Inverter: SinePower MSI1812T/MSI1824T
➤ Install inverter remote control MCR9 in an easily-accessible place (jumper closed, refer
to remote control installation manual) and connect its cable to the inverter.
108
ECL-76, ECL-102, ECL-103
EN