Werbung
17
Technical Information
Programming
Figure 38
Mode Menu
260/297
MODE
PUMP SETTING
INPUT / OUTPUT
SETPOINT
R1 SETTING
SETPOINT
R2 SETTING
GAUGE
SERIAL
MODE: permits selection (see Flow 1/6) of the operating
mode of the controller from those indicated below:
FRONT: accepts commands from the front panel
REMOTE: accepts commands from the remote input
connector
SERIAL: accepts commands from the serial interface (or
Profibus interface if present)
PROFIBUS: this operating mode is present only if the
Profibus interface is installed on the controller
TwisTorr 84 FS AG Rack Controller User Manual / 87-901-037-01 (A)
PROFIBUS
HIGH SPEED ADJ
F. 2
START MODE
R1/R2 TRESHOLD
F. 4
PRESSURE UNIT
BAUD RATE
F. 6
Flow 1/6
FRONT
REMOTE
SERIAL
F. 3
F. 5
Werbung
Kapitel
