Positioning The Logs; Connecting To The Gas Supply; Throttle Ring; Operating Instructions - Dru DIABLO Installationsvorschrift Und Gebrauchsanweisung

INSTRUCTIONS FOR INSTALLATION
For safety reasons a guard should be placed in
front of the fire at all times

Positioning the logs

• Sprinkle the vermiculite evenly over the burner tray and
the surrounding tray, (the vermiculite tray).The vermiculite
is in a plastic bag with the logs.
• Place the largest log against the back wall.
• Sprinkle a few brown embers, black and yellow chips on
top of the vermiculite to create a glowing effect on the
burner bed.The embers and chips are in little bags with
the log set.
• NB: The black and yellow chips are to be sprinkled in the
vermiculite tray only, not in the burner tray.
• Make sure that no vermiculite gets on or into the pilot
light burner, and that no vermiculite is blocking the over-
flow opening (slit) in the burner tray. (see fig. 6, pos 3).
• Now position the rest of the logs as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been manu-
factured specifically for this appliance.

Connecting to the gas supply

Connect the gas supply to the gas control valve with 3/8"
inner thread.
In the connecting pipe an approved connecting gas tap
with a coupling should be included.This should be placed
outside the casing.
fig. 5
10

OPERATING INSTRUCTIONS

Furthermore please note that:
• Expel all air from the supply pipe before coupling the
appliance.
• Do not turn the control tap when connecting the gas
supply.
• Avoid any tension on the control tap or
pipes.
• Check that the connection is gastight.
Throttle ring (fig. 6, page 29)
The throttle ring (pos 1) is factory-adjusted to
8 mm.This will produce attractive flames. A
qualified fitter may adjust the distance between
the two marks on the jet
(pos 2) to change the appearance of the
flames.The larger the flames, the more they
will "dance", but soot formation will also be
more likely (dirty windows).The smaller the
distance the more static the flames and the
more intense the glow on the burner bed.
NB:The air inlet may never be closed.
See the marks on the jet.
OPERATING INSTRUCTIONS
The control buttons are located behind the flap at the bot-
tom of the heater front.

Lighting

Press button A and turn to the left to the small flame
The flame will ignite at
behind the glass is alight. If that is the case, hold button A
firmly pressed for another 5 seconds.Then release button
A and check that the pilot light is still burning. Now turn
button A to the large flame
valve of the control block. Depending on the setting of the
control button B, high or low flames will be visible.
Remote control
The level of the flames can be regulated with the remote
fig. 7
. Check that the pilot light
, which will open the main
.