Bosch SCT 815 Originalbetriebsanleitung Seite 18

en | 18 | SCT 815 | Operation
If the back of the laser range finder does not
touch the rear stop of the horizontal tray, there
will be observational errors.
12. Use the laser range finder to position the SCT 815
at the precise specified distance from the front of
the vehicle.
 The position of the SCT 815 is correct when the
laser range finder reading matches the
specification from the brief instructions.
---Separator---
4.4 Aligning the SCT 815 with the vehicle's
longitudinal center plane
1. Attach the line laser
 15(1)
and use the arrestor cable
2. Use the spirit level on the line laser mount
and the positioning feet
SCT 815.
1 1
2 2
 15: Aligning the SCT 815
(1) Line laser
(2) Spirit level on the line laser mount
(3) Positioning feet
(4) Arrestor cable
 WARNING – severe eye damage from laser beam.
3. Never look directly into the laser source.
4. To test function, hold an object in front of the line
laser exit point.
5. Switch on the line laser.
 The laser line now runs across the vehicle.
6. Align the SCT 815 in such a way that the laser line
touches the manufacturer badge on the
 16(2)
front of the vehicle and the antenna.
1 689 989 362 | 2018-08-01
to the line laser mount,
 15(4) to secure it.
 15(2)
to level the
 15(3)
4
3 3
1
3
2
 16: Aligning the SCT 815
(1) Line laser
(2) Projected laser line
(3) Manufacturer badge
(4) Antenna
Depending on the vehicle, other fixed points
can be used to align the SCT 815 with the
vehicle's longitudinal center plane using the line
laser.
---Separator---
4.5 Adjusting the height of the prismatic
reflector
The height of the prismatic reflector is specified in the
corresponding brief instructions. The height specific to
the vehicle is found in the column with the following
pictogram.
 17: Pictogram for the height of the prismatic reflector
The vehicle-specific height from the brief
instructions applies if the vehicle rests on the
same surface as the SCT 815. If the vehicle
rests on a lift or leveling surface, the difference
in height must be measured. The measured
height must be added to the vehicle-specific
height from the brief instructions.
1. Use the corresponding brief instructions.
2. Look up the height of the prismatic reflector for the
relevant vehicle.
3. Position the mount for the laser range finder
on the prismatic reflector
(1)
4
 18
.
 18(2)
Robert Bosch GmbH