Bosch SCT 815 Originalbetriebsanleitung Seite 16

en | 16 | SCT 815 | Operation
The plastic screws are intended as a stop so the
prismatic reflector cannot slide off the tool
holder by accident. 3 plastic screws are
included in the scope of delivery. The third
plastic screw is intended as a spare.
1 1
 8: Securing the plastic screws
(1) Plastic screws
---Separator---
4. Operation
4.1 Positioning the SCT 815 for radar
sensor calibration
1. For position information for the SCT 815, refer to
the corresponding brief instructions.
1
 9: Position information from brief instructions
(1) Distance from the vehicle
(2) Height of the prismatic reflector
(3) Offset from the vehicle's longitudinal center plane
 CAUTION – Risk of injury from falling objects.
2. Always use the arrestor cable to secure the line
laser.
3. Use the laser range finder to position the SCT 815 at
the specified distance from the vehicle.
"Adjusting the distance between the SCT 815 and the
vehicle"
4. Use the spirit level on the line laser mount and the
spirit level on the prismatic reflector to align the
SCT 815.
5. Use the line laser to align the SCT 815 with the
vehicle's longitudinal center plane. Aligning the
"Aligning the SCT 815 with the vehicle's longitudinal
center plane"
6. Check the alignment of the SCT 815 and the
distance from the vehicle, and adjust them if
necessary.
7. Use the laser range finder to set the specified height
of the prismatic reflector.
of the prismatic reflector"
1 689 989 362 | 2018-08-01
2
3
 17
 18
 18 "Adjusting the height
8. Move the prismatic reflector on the tool holder
according to the offset from the vehicle's
longitudinal center plane.
to 25cm) from the vehicle's longitudinal center plane"
— If the offset from the vehicle's longitudinal center
plane is more than 25 cm, use two auxiliary lines
to move the SCT 815 according to the offset from
the vehicle's longitudinal center plane.
"Setting the offset (25cm and above) from the
vehicle's longitudinal center plane"
9. Remove the mount for the laser range finder.
10. Remove the line laser.
The metallic surfaces of the mounts for the
laser range finder and the line laser may
interfere with calibration.
11. Use diagnostic software to calibrate the radar
sensor.
---Separator---
4.2 Attaching the line laser to the SCT 815
1. Pay attention to the positioning pins
line laser mount.
2. Pay attention to the drill bushings
bottom of the line laser.
5
4
1 1
3
 10: Attaching the line laser
(1) Positioning pins
(2) Drill bushings
(3) Magnet
(4) Arrestor cable
(5) Retaining ring
3. Position the line laser with the drill bushings on the
positioning pins.
 The line laser is pulled in by the magnet
in the mount.
 The positioning pins are in the drill bushings of
the line laser.
 The line laser sits firmly in the mount and cannot
be twisted.
4. Secure the arrestor cable
mount to the retaining ring
 The line laser is secured against falling.
---Separator---
 19 "Setting the offset (up
 20
 10(1) on the
on the
 10(2)
2 2
 10(3)
on the line laser
 10(4)
of the line laser.
 10(5)
Robert Bosch GmbH