Channel Level - Pioneer HTP-076 Bedienungsanleitung

„ 4. Channel Level
Adjust the volume level of each speaker.
Setting Item Default Value
Front Left 0.0 dB
Center 0.0 dB
Front Right 0.0 dB
Height Left 0.0 dB
Height Right 0.0 dB
Surround Right 0.0 dB
Surround Left 0.0 dB
Subwoofer 0.0 dB
Setting Details
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Select a value between "-15.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Contents Connections
≫
„ 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item Default Value
Dolby Enabled 6.0 ft/1.80 m
Speaker to Ceiling
Reflex Optimizer Off
• This setting can be selected when "Configuration" - "Height Speaker" is set to "Dolby
Speaker".
„ 6. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value
Speaker On
Virtualizer
75
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
• The function is not effective if the listening mode
is Pure Direct.
Setting Details
"On": Listening modes such as F.S.Surround that
have virtual speaker effects can be selected.
"Off": Listening modes such as F.S.Surround that
have virtual speaker effects cannot be selected.
≫