Initial Setup With Auto Start-Up Wizard; Operations - Pioneer HTP-076 Bedienungsanleitung

Initial Setup with Auto Start-up Wizard

Operations

TV's REMOTE
Inputs
INPUT
TV
HDMI 1
HDMI 2
HDMI 3
Contents Connections
≫
When you turn the unit on for the first time after purchase, the Initial Setup screen
is automatically displayed on the TV to allow you to make settings required for
startup using simple operations following on-screen guidance.
1. Switch the input of the TV to the input connected to the unit.
2. Put batteries into the remote controller of this unit.
3. Press on the remote controller to turn the unit on.
4. When the language selection screen is displayed on TV, select the language
with the cursors
• Select the item with the cursors of the remote controller, and press ENTER to
confirm your selection. To return to the previous screen, press
• If you have terminated the Initial Setup halfway, turn this unit to standby mode.
Then turning the power on again can display the Initial Setup again.
The Initial Setup appears on the screen each time the power is turned on
unless the Initial Set up is completed or "Never Show Again" is selected on the
first screen.
85
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
/ and press ENTER.
/ / /
ENTER
Setup
≫ ≫
.