Panasonic WV-Q169E Handbuch Seite 8

r Rotate the camera in the arrow direction
so that the protrusion of the camera
attachment is aligned with the "LOCK"
position to
between the camera and camera attach-
ment.
Engage the camera with the camera
attachment.
t Use the driver bit (supplied with the cam-
era) to loosen the screws that secure the
camera enclosure and remove the enclo-
sure from the camera main body.
Secure the camera to the camera attach-
ment with the camera fixing screw (red):
(Recommended tightening torque: 0.78
N·m {0.58 lbf·ft})
Important: The camera fixing screw shall be
securely tightened. Otherwise, water
exposure may cause damage or mal-
function of camera, or camera dropping
may result in injury.
(Recommended tightening torque: 0.78
N·m {0.58 lbf·ft})
8
eliminate any backlash
Protrusion
LOCK OP EN
Enclosure
Camera fixing screw
y Adjust the camera.
Refer to the manual of the camera.
u Use the driver bit (supplied with the cam-
era) to tighten the screws that secure the
camera enclosure and mount the enclo-
sure on the camera main body.
9. Mount the decorative cover on this
mount bracket.
• Mount the decorative cover on the cam-
era mounting plate with engaging the
projections of the decorative cover with
the hooks for the decorative cover.
• Turn the decorative cover clockwise until
the cover clicks while pressing the cover
upward to lock the cover.
Hooks for the
decorative
cover
Projections