Panasonic WV-Q169E Handbuch Seite 6

4. Connect this mount bracket to the tip
of the safety wire.
Safety wire (Accessory)
Mount bracket
5. Insert the 1st anchor bolt into the
mounting hole of the mount bracket.
Mounting hole
6. Secure the mount bracket to the ceil-
ing board with the ceiling board fixing
screws (4 positions).
Turning the ceiling board fixing screws
clockwise provides
tightening between the bottom of the
mount bracket and ceiling board fixing
bracket resulting
securing.
(Recommended tightening torque:
0.78 N·m)
6
Roof space
Insert the mount
bracket into the hole
ceiling board
in mount bracket
Important: When securing this bracket on
the ceiling, make sure that the four ceil-
ing board fixing brackets are open as
shown in the following figure.
1st anchor bolt
Double nuts (locally
procured)
Ceiling board
fixing bracket
Ceiling board
7. Use double nuts (locally procured) to
secure the mount bracket after insert-
ing the 1st anchor bolt.
8. Follow the procedure according to the
model of the camera to be installed.
<Installing WV-NW484S>
q Use the driver bit supplied with the cam-
era to remove the screws that secure the
camera enclosure and remove the enclo-
sure from the camera main body.
Important: Refer to the Operating inst-
ructions of the camera as well.
w Perform camera wiring.
e Align the screw holes of the mount
bracket with the 4 mounting screws of
the camera main body and tighten them.
(Recommended tightening torque:
0.78 N·m)
Ceiling
board fixing
screw
Turn clockwise