Show The Active Errors, Warnings And Reminders - Hach NA5600 sc Na+ Wartung Und Fehlerbehebung

Table of contents
Show the active errors, warnings and reminders
on page 3
Maintenance schedule on page 4
Replace the calibration and reactivation solutions
on page 4
Replace the conditioning solution
Replace the KCl electrolyte
Replace an input power fuse
Prepare the analyzer for a long-term shutdown
on page 11
Troubleshooting on page 17
Safety information
Refer to the installation user manual for general safety information, hazard descriptions and
precautionary labels descriptions.

Show the active errors, warnings and reminders

The display background and the status indicator light will change to red when an error occurs or to
yellow when a warning occurs.
• Error-red display background and status indicator light. A significant problem occurred that
affects the instrument operation. The current measurement stops and the analyzer goes into
shutdown mode.
• Warning-yellow display background and status indicator light. An event occurred that can cause
a future problem. The analyzer continues to operate.
• Reminders-wrench symbol shows on the display and yellow status indicator light. The time for a
maintenance task has passed.
Do the steps that follow to show the active errors, warnings and reminders:
Note: To see all of the possible errors, warnings and reminders and their help information, push diag, then select
ANALYZER HELP.
1. Push diag, then select DIAGNOSTICS. The active errors, warnings and reminders are shown.
2. Select an error, warning or reminder from the list.
3. Select an option.
Option
ACKNOWLEDGE Acknowledges the selected error, warning or reminder. When all of the active errors,
VIEW HELP
Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
on page 6
on page 8
on page 10
Description
warnings and reminders are acknowledged, the display background changes back to
white and the status indicator light changes back to green.
Shows help information for the selected error, warning or reminder.
Plumbing schematic
Start an analyzer test
Start a 4-20 mA output or relay test
Show the analyzer information
Show the analyzer status and system data
on page 24
Show Service information
Replacement parts and accessories
D A N G E R
on page 22
on page 22
on page 23
on page 24
on page 25
on page 25
English 3