Show Service Information; Replacement Parts And Accessories - Hach NA5600 sc Na+ Wartung Und Fehlerbehebung

Option
MODBUS STATS
SYSTEM DATA
I2C DATA

Show Service information

Use the Service menu to show or set the service history for the instrument parts.
1. Push diag.
2. Select SERVICE.
3. Select an option.
Option
CONSUMABLE
SERVICE PART
ANNUAL
MAINTENANCE
EDIT ELECTRODES
SN
SERVICE HISTORY
POST ENABLE

Replacement parts and accessories

Personal injury hazard. Use of non-approved parts may cause personal injury, damage to the
instrument or equipment malfunction. The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate distributor or refer to
the company website for contact information.
Reagents and standard solutions
Description
3M KCl electrolyte solution
3M KCl electrolyte solution
Diisopropylamine (DIPA) 99%
Description
Shows the status of the Modbus ports: sensor, controller, network and service. Shows
the number of good and bad transmissions.
AMBIENT TEMP—Measured ambient temperature in Celsius (C). POWER SOURCE
FREQUENCY—Line power frequency (Hz). POWER SOURCE VOLTAGE—Line power
(AC). 12V VOLTAGE—Measured power supply voltage (VDC). 3.3V VOLTAGE—
Measured regulated 3.3 V supply (VDC). 12V CURRENT—Measured 12 V power supply
current (amperes).
Shows the communication information (I
Description
Shows a list of consumable parts. Shows the date of the last replacement and the
number of days since the part was replaced. Reset the counter after a part is
replaced.
Note: The SERVICE PART option is only available for Service use only.
Shows a list of parts and the date of the last service. The customer service
representative resets the counter after a part is replaced.
Shows the date of the last annual maintenance, the date of the next annual
maintenance and the number of days before the next annual maintenance is due.
Reset the counter after annual maintenance.
Records the serial numbers of the electrodes.
Shows the maintenance tasks done and the date (e.g., Replace reactivation
solution). START TIME— Shows the data recorded after the selected date and
time. NUMBER OF READINGS— Shows the selected number of data points.
NO—Hardware diagnostics are not done when power is applied to analyzer. YES—
Hardware diagnostics are done when power is applied to analyzer.
W A R N I N G
2
C) and the version number.
Quantity
250 mL
500 mL
1 L
Item no.
LZW9500.99
363140,00500
2834453
English 25