Silvercrest SRR 3.7 C3 Bedienungsanleitung Seite 19

3) Clean all parts under running water and then allow them to dry fully .
4) Reassemble the cutting unit 2 . Use the following illustrations for
guidance:
–
Place the three shaving heads in the recesses of the cutting
unit 2 . Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening .
–
Place the round blades into the shaving heads with the blade
tips to the front .
–
Press the two tabs of the retainers together and place them
back into the catches of the cutting unit 2 and release the tabs .
The cutting unit 2 is now reassembled .
5) Remove loose hairs from the shaver with the brush e .
6) Replace the cutting unit 2 on the shaver . Ensure that it snaps
into place and is seated firmly .
■ Clean the housing with a moist cloth .
SRR 3.7 C3
GB │ IE │ NI │ 15 ■