Mounting; Installation - Danfoss FH-CWD Gebrauchsanweisung

Instruction FH-CWD Thermostat

2. Mounting

! Wherever possible, the room thermostat should be
installed where the effects of sunlight, draught, and
other heaters (eg. TV's), etc. are avoided.

3. Installation

Installing the Room Thermostat- fig. 5 and fig. 6
• Remove the connection cable between front and
back part
• Connect the thermostat correctly to mains supply
according to the Wiring Diagram - fig 6
• Mount the thermostat by using the enclosed
screws to the wall box
• Mount the front correctly.
Wiring Diagram – fig. 6
The product must be connected to the following leads:
• Term L:
• Term NO:
• Term NC:
• Term N:
• Term 2:
• Terminal S2:
• Terminal S1:
Produced by Danfoss Floor Heating Hydronics 05.2011
Phase (L) AC85-250V, 50/60 Hz
Valve (NO)
Valve (NC)
Neutral (N)
Empty
Floor sensor
Floor sensor
VI.CU.B2.2D
7