Specifications; Safety Instructions - Makita UC120D Betriebsanleitung

ENGLISH
1 Button
2 Battery cartridge
3 Screw
4 Sprocket guard
5 Hex wrench
6 Bolt
7 Guide bar
8 Cutter
9 Revolving direction
10 Sprocket
11 Chain tension adjusting
spring

SPECIFICATIONS

Model
Chain speed per minute ............................ 160 m/min
Effective cutting length ..................................115 mm
Saw chain type ..................................................25AP
Saw chain pitch ................................................... 1/4"
No. of drive links .................................................... 42
Net weight ........................................................ 2.2 kg
Rated voltage ..............................................D.C. 12 V
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Intended use
The tool is intended for cutting off branches.

SAFETY INSTRUCTIONS

WARNING! When using battery operated tools
basic safety precautions, including the following,
should be followed to reduce the risk of fire, leak-
ing batteries and personal injury: Read these
instructions before operating this product and
save these instructions.
For safe operation:
1. Keep work area clean
– Cluttered areas and benches invite injuries.
2. Consider the work environment.
– Do not expose the tool to rain. Keep work area
well lit. Do not use tools in the presence of
flammable liquids or gases.
3. Keep children away
– Do not let visitors touch the tool. Keep visitors
away from work area.
4. Store batteries or idle tools
– When not in use, tools and batteries should be
stored separately in a dry, high or locked up
place, out of reach of children.
– Ensure that battery terminals cannot be
shorted by other metal parts such as screws,
nails, etc.
6
Explanation of general view
12 Concave portion of guide bar
13 Chain oil
14 Saw chain
15 Lock-off button
16 Switch trigger
17 Scabbard (chain cover)
18 Battery cover
19 Tip guard
20 Cutting force pushes chain
saw toward operator.
21 Front face of housing
5.
UC120D
6.
7.
8.
9.
10. Do not abuse the supply cord (if fitted)
11. Secure the work
12. Do not over-reach
13. Maintain tools with care
14. Disconnect tools
22 Cutting force pulls chain saw
away from operator.
23 Shallow undercut
24 Finish cut from top
25 Chain saw will be pinched.
26 Branch will splinter.
27 Screwdriver
28 Spike
Do not force the tool
– It will do the job better and safer at the rate for
which it was intended.
Use the right tool
– Do not force small tools or attachments to do
the job of a heavy duty tools. Do not use tools
for purposes not intended.
Dress properly
– Do not wear loose clothing or jewellery, they
can be caught in moving parts. Non-skid foot-
wear is recommended when working outdoors.
Wear protecting hair covering to contain long
hair.
Use protective equipment
– Use safety glasses and if the cutting operation
is dusty, a face or dust mask.
Connect dust extraction equipment
– If devices are provided for the connection of
dust extraction and collection ensure these are
connected and properly used.
– Never carry the tool by the cord or yank it to
disconnect from the socket. Keep the cord
away from heat, oil and sharp edges.
– Use clamps or a vice to hold the work. It is
safer than using your hand and it frees both
hands to operate the tool.
– Keep proper footing and balance at all times.
– Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubrication and changing accessories. Inspect
tool cords periodically and if damaged have
repaired by an authorized service facility.
– Where the design permits, disconnect the tool
from its battery pack when not in use, before
servicing and when changing accessories such
as blades, bits and cutters.