Safety; Use Of The Simplified Remote Control - Vortice VORT LETO MEV Betriebsanleitung

610 - Telecomando RF Mev:Layout 1
ENGLISH

Safety

Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician
or Vortice. Do not leave packaging within the reach
of children or infirm persons
• This appliance is not suitable for use by children or
by individuals with reduced physical, sensorial or
mental capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed
in its use by a person responsible for their safety
Children must always be supervised to ensure that
they do not play with the appliance.
• Store the appliance out of the reach of children and
infirm persons after deciding to disconnect it from
the power supply and use it no more.
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• The maintenance instructions must be followed to
avoid damage and/or excessive wear and tear to
the appliance
• Do not leave objects standing on the appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not
use it and contact Vortice immediately.
6
27/10/2009 17.19 Pagina 6
Use of the Simplified Remote
Control
The simplified remote control has 9 buttons with the
3 3 1
following functions (fig 1):
• Button 1: minimum speed;
• Button 2: medium speed;
• Button 3: maximum speed;
• TIMER button: T10, T20, T30, T300, T OFF: The first
four buttons are for setting the timer to run the
appliance at max speed for 10, 20, 30 and 300
minutes; T OFF is used to cancel timer settings;
once the set period of running at max speed has
expired, the appliance will return to operating at its
previously set speed.
Synchronising the appliance/remote control unit
Before being used, remote control units have to be
synchronised with an appliance. This task is looked
after by the installer.
Synchronising a remote control unit
Remove the cover on the appliance.
Turn the appliance ON.
Wait until the DL2 LED on the appliance starts
flashing.
Press the 1 and the ON/OFF buttons at the same
time. Press the 3 and the T300 buttons at the same
time.
If this sequence has been correctly acquired, 10
seconds after the DL2 LED begins flashing, the
appliance will memorise the remote control unit's ID
and will only accept commands from that unit.
Up to 3 different remote control units can be
synchronised for each appliance. On attempting to
synchronise a fourth unit, the appliance will delete the
setting for the oldest unit.
As soon as you have completed the procedure, you
are advised to check that the units are synchronised,
for example, by changing the speed setting.
If this fails, repeat the procedure.
(Nero/Black pellicola)
3
1 2
T10 T20 T30
ON/
T300 TOFF
OFF