Troubleshooting; Options - Yamaha P-60 Bedienungsanleitung

Troubleshooting

Problem
The P-60 does not turn on.
A click or pop is heard when the power is
turned on or off.
Noise from the speakers or headphones is
audible.
The overall volume is low, or no sound is
heard.
The foot switch has no effect, or the sound
continuously sustains even when the foot
switch is not pressed.
The foot switch seems to produce the oppo-
site effect. For example, pressing the foot
switch cuts off the sound and releasing it sus-
tains the sounds.

Options

• Foot Pedal FC3
• Foot Switch FC4
• Keyboard Stand L-120 (for P-60; black and mahogany two-tone finish)
26

Troubleshooting

Troubleshooting/Options
P-60 P-60
The P-60 has not been plugged in properly. Insert the adaptor plug into an AC outlet
and the adaptor socket into the unit securely. (page 10).
This is normal when electrical current is being applied to the instrument.
The noise may be due to interference caused by the use of a mobile phone in close
proximity to the P-60. Turn off the mobile phone, or move it further away from the P-60.
• The Master Volume is set too low. Set it to an appropriate level using the [MASTER
VOLUME] control.
• Make sure a pair of headphones is not connected to the headphones jack.
• Make sure that Local Control (page 24) is ON.
The pedal cord may not be properly connected. Make sure to securely insert the pedal
cord into the [SUSTAIN PEDAL] jack (page 11).
The polarity of the foot switch is reversed. Make sure that the foot switch plug is prop-
erly connected to the [SUSTAIN PEDAL] jack before turning on the power.
Do not press the pedal while turning the power on.
L-60W (for P-60S; silver and cherry two-tone finish)
Possible Cause and Solution