Adjusting The Self-Propel Drive Cable; Cleaning Under The Machine Housing - Toro 29639 Bedienungsanleitung

of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Adjusting the Self-propel Drive
Cable
Whenever you install a new self-propel drive cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive cable.
1. Loosen the cable-support nut (Figure 31).
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel drive bar
3. Cable jacket
2. Hold the self-propel drive bar 25 to 38 mm (1 to 1-1/2
inches) from the handle (Figure 31).
3. Pull down the cable jacket (toward the machine) until
there is no slack in the cable (Figure 31).
4. Tighten the nut on the cable support.
5. Release the self-propel drive bar and ensure that the
cable is loose.
Note: The cable must be loose with the self-propel
drive bar in the released position; otherwise, the
machine may creep when you disengage the bar.
Figure 31
4. Cable-support nut
5. Cable support
Cleaning under the Machine
Housing
Service Interval: After each use
WARNING
The machine may dislodge material from under the
machine housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
1. With the engine running on a flat paved surface, spray
a stream of water in front of the right rear wheel
(Figure 32).
The water will splash into the path of the blade,
cleaning out the clippings.
2. When no more clippings come out, stop the water and
move the machine to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
15
Figure 32