Remedying Faults; Warranty - Kärcher miolectric MNT 3500 Betriebsanleitung

8. Remedying faults

You can remedy any faults yourself as follows.
Fault
Suction unit does not
start
Suction force decreases
Dust emitted during
suction
Automatic cutout does
not function during wet
suction
If these tips are of no help to you, please consult your nearest Kärcher service center.

Warranty

The warranty conditions provided by our responsible Kärcher company apply in every country. We
will remedy faults on your Kärcher unit free of charge within the warranty period and within the
framework of these conditions if the cause of the fault is a material or manufacturing defect.
The Kärcher guarantes only takes effect if your dealer fills in the enclosed reply coupon in full when
you make youe purchase, including his stamp and signature, and if you then send this coupon to the
Kärcher company in your country.
To claim on the warranty, please contact your dealer or the nearest Kärcher branch. Please always
send in the unit with its accessories and receipt/invoice.
Dear Kärcher customer:
We use recycling paper for these operating instructions for environmental protection reasons.
We are sure that you will appreciate this.
12
BT_660GB.PM6
Possible cause
No electrical voltage
Water level in container too
high, suction unit switches off
automatically
Filter, nozzle, suction hose or
suction pipe blocked.
Paper filter bag or dirt
container full
Container seal leaks
Flat folding filter missing or
not correctly inserted
Flat folding filter missing, not
correctly inserted or faulty
Electrodes contaminated
12
5.959-660
Remedy
Check fuse, cable, plug
and socket
Empty container; push the
ON/OFF switch twice
Check and clean if
necessary
Change paper filter bag or
empty dirt container
Press seal back into
groove; replace if damaged
Insert filter correctly
Check filter seat and/or
replace filter
Clean electrodes and allow
suction unit to run dry until
no more water comes out
of the fan opening.
08.02.01, 14:10