Hama RCR 110 Bedienungsanleitung Seite 6

5.5. Dual Time settings and display
• Dual Time allows you to set and display a second, completely
independent time (8).
• Press the MODE button (4) repeatedly until SECOND TIME
is displayed.
• Press and hold the MODE button (4) for approximately 3
seconds. The hours display begins to ash.
• Press the ▲ button (3) or the
and con rm your selection by pressing the MODE button (4).
The minutes display begins to ash.
• Repeat the process to set the minutes.
• To select the individual values, press the ▲ button (3) or the
button (2) and con rm each selection by pressing the MODE
button (4).
5.6. Backlight
If you press the LIGHT-SNOOZE button (11), the display will light
up for approx. 5 seconds.
5.7. Projection
Activating/deactivating
Power supply from batteries
• Press the LIGHT-SNOOZE button (11) to project the display onto
the wall or ceiling for ve seconds.
Power supply from batteries + mains:
• Slide the CONTINUE PROJECTION sliding switch (9) up
towards to set the projection to sustained mode.
• Slide the CONTINUE PROJECTION sliding switch (9) down/
away from to deactivate sustained mode.
Projection settings:
• Turn the projection arm (8) forward/back to project the display
onto the wall or ceiling.
• Press the FLIP button (7) to rotate the projection by 180°.
• Turn the ROTATE control dial (12) to further rotate the projection
by up to +/–90°.
• Turn the FOCUS control dial (13) to focus the projection.
• Press and hold the FLIP button (7) for approx. 3 seconds to
switch the projection between displaying the time and displaying
the time and temperature.
Note – Projection
• At a distance from the projection lens to the wall/ceiling of
about 2 m / 4 m, the size of the display projection on the wall
is about 10 cm / 18 cm.
• By default, the projection shows the time. See the instructions
above to set the projection to alternate between the time and
the temperature.
button (2) to select the hour
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents. Make sure that water does not
get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Technical Data
RCR 110 radio-controlled alarm clock
Power supply
Measuring range
Temperature
9. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00104952] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address: www.hama.com -> 00104952 -> Downloads.
Frequency band(s)
5.0 V
2 x AA batteries
Power supply unit:
In: 230 V 50 Hz
Out: 5 V 130 mA
0°C – +50°C/ 32°F – +122°F
77,5 kHz
5