Whirlpool SPIW309A3WF.1 Gebrauchsanweisung Seite 4

LIVE APPLICATION REMOTE CONTROL /
SET UP PROCEDURE
The LIVE feature allows to operate and supervise the air conditioner remotely by external device.
process. This process is necessary to register your air conditioner and connect to your home network.
The set up procedure has to be carried out only once. You have to carry it out again if you change your router set
up properties (network name or password or data provider).
BEFORE STARTING THE SET UP PROCESS
1. To use this feature You need to own:
• a smart phone running Android 4.3 (or higher) with a 1280x720 (or higher) screen or a tablet or a smart
phone running iOS 8 (or higher);
• a wireless router 2.4Ghz WiFi b/g/n connected to internet (verify with your smart device that the signal
strength of your home wireless network close to the appliance is good).
2. Download & Install the free application: LIVE on your Android smart-phone or iPAD/iPhone from the store.
The App will guide you, step by step, through the installation process.
3. If You do not have an account already, create one and subscribe to service by accepting the legal terms to be
4. Register your air conditioner following the App instructions. For the registration process You will need the
by 13 numbers and letters. You can take a note of your appliance SAID here:
SAID ... ... ... ... ... ... ... ... ... ... ... ... ...
• Before starting the installation process turn on your router and verify that the wireless signal of your home
to the Wi-Fi router, disable any other data connections, and place the device close to the appliance. Open any
internet web page in a browser and check that it is downloaded fast correctly.
If the internet connection of your home is working correctly but the page is not downloaded, you may need to
install a Wi-Fi extender device (not provided with the appliance).
• If your router supports WPS 2.0 (or greater), follow the automatic set up procedure to connect your appliance
to router. If your router is not supported by WPS, follow the manual setup procedure.
Follow the instructions of your 6th Sense Live application on your smartphone to connect the appliance to
This procedure is applicable only if your router supports WPS2.0 (or greater)
1. On your remote control: • press the WiFi button, wait a few seconds and then, press Hum%+ and Hum%-
buttons simultaneously for 3 seconds: this activates the provisioning process. The appliance is being set to a
"search" mode for a local network. • The Connectivity icon on the air conditioner starts blinking fast.
2. On wireless router press the WPS button to establish a connection between the two products.
An indicator light on your router will begin blinking.
3.
This may take few minutes.
4. The appliance tries to connect to Backend system. Connectivity button becomes steady.
connections to home network using WPS. Try the procedure again and if not successful, than use the MANUAL
SETUP INSTRUCTION.
This procedure uses the Micro Access Point technology and is applicable if Your router does not support WPS
1. Before starting the setup procedure please take note of the home wireless network name (SSID), its
PASSWORD, and the SAID of air conditioner. They will be required during the installation process.
2. Turn ON your router and make sure the Internet connections is working.
4