Herunterladen Inhalt Inhalt Diese Seite drucken

Battery Status; Using The Battery Charger; Maintenance; Thorough Cleaning - Cembre B-TC650-SC Bedienungsanleitung

Hydraulisches akku-schneidewerkzeug
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15

2.7) Battery status

The battery is equipped with LED indicators that indicate the
remaining battery life at any time by pressing the adjacent
button (9):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing : minimum charge, replace the battery.
Tool LEDs (4) illuminated combined with an alarm audible when the operating button (5)
is pressed (Ref. to Fig. 3), indicate that the battery voltage has dropped below a minimum
safety threshold; under these conditions the tool will not start, and it is necessary to recharge or
replace the battery.
The approximate time to fully recharge a battery is about 80 minutes.
After each working cycle, and after the extraction of the battery from the tool, an integrated
battery cut-o device will operate after 70 s approx. Then the LED nearest to button (9) will
ash 5 times each 14 s approx. The battery will be reactivated when it is reintroduced into the tool
and the operating button is pressed.

2.8) Using the battery charger

Carefully follow the instructions in the battery charger user manual.

3. MAINTENANCE

The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
the following points, should help to maintain its optimum performance:

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device. Every day, after use, the tool must be
wiped with a clean cloth taking care to remove any residue, especially close to pivots and move-
able parts.
Do not use hydrocarbons to clean the rubber parts.
Regularly lubricate the moving parts and pivot pins of the head with a few drops of oil.
3.2) Cleaning of the rubber handgrip
To avoid the accumulation of swarf inside the rubber handgrip (3) periodically fold back the
handgrip near the blades and carefully brush out any debris.
3.3) Storage case
When not in use, the tool should be stored and transported in the metal case, to prevent damage.
Metal case: VAL B-TC950, size 565x410x132 mm (22.2x16.1x5.2 in.), weight 6,7 kg (14.7 lbs).
9
8

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

B-tc650-sctB-tc650-sceB-tc650-sca

Inhaltsverzeichnis