Problem Solving - Teka CMB1 Bedienungsanleitung

Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the product
instructions.
• If your kitchen hood is painted, use lukewarm water and
a neutral soap.
• Never use metallic scourers, nor abrasive or corrosive
products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
The lamps do not light up.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their useful
life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
To remove the filters from their fittings, press lightly on the
locks and then pull them off.
The metal filters can be cleaned by soaking them in hot
water with neutral detergent until the fat dissolves and then
rinsing them under the tap or using special anti-grease
products. They can also be washed in a dishwasher. In this
case, it is advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic surface
(blackening it), although this will not affect its fat retention
capacity.
Once clean, leave them to dry off and then fit them onto
the kitchen hood.
• Lamps included in this product are designed
• These lamps are not apt for lighting domestic areas

Problem solving

Possible cause
The mains cable is not
connected to the network.
There is no current in the
network.
Filters are saturated with fat.
Obstruction in the air outlet.
The lamps are blown
The lamps are slack.
Active charcoal filters (Optional)
Cleaning the metal filters
Lamps
exclusively for the illumination of the cooking area.
Solution
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
Change the lamps.
Tighten the lamps.
network.