Establishing A Bluetooth Connection - Silvercrest SKBT 4 B2 Bedienungsanleitung

5.3

Establishing a Bluetooth connection

NOTES:
• The identification of the device is "SKBT 4 B2".
• After turning it on, the device automatically tries to reconnect to the last
paired device.
• Please note that establishing the connection may vary slightly depend-
ing on the device and the software used.
• The device switches off if no Bluetooth connection can be established
within 10 minutes.
• If you pass the device on to someone else, in order to protect your data
and your privacy, you should disconnect the Bluetooth connection to the
device and delete it from the connection list on your smartphone.
1. Press the button 6 to switch on the device. An audio signal sounds and
the LED on the button 6 lights up. The charging indicator 16 shows
briefly the charging state of the battery.
2. Switch on the audio device (e.g. smartphone) and start the Bluetooth
connection.
3. The audio device will now receive the device identification
"SKBT 4 B2". If nothing happens, press button
button 6 flashes.
4. Establish a connection to the headphones on the audio device. If you
are asked for a password, enter "0000". Both devices are now inter-
connected. The LED on the button 6 lights up and an audio signal is
heard.
NOTE: usually, audio devices remember the identification of the device. In
this case, it may not be necessary to establish the connection manually again
if the Bluetooth function is activated.
5. Now, start the playback of a music track at the audio device. The
sound is played by the headphones.
6. Use the 19,
sic track.
12
GB
21 and 18 buttons to select and control the mu-
5 until the LED on the