Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Speakers; Connecting Speaker Cables; Bi-Wire Connection - Yamaha R-N402 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für R-N402:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 122

Connecting the speakers

■ Connecting speaker cables

aRemove approximately 10 mm (3/8") of insulation
from the ends of the speaker cable and twist the bare
wires of the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the
side (upper right or bottom left) of the terminal.
d Tighten the terminal.
10 mm
a a
(3/8")
c c
b b
d d
Red:positive (+)
Black:negative (–)
■ Connecting via banana plug
(North America, Australia, Brazil,
General models only)
Tighten the knob and then insert the banana plug into the
end of the corresponding terminal.
Banana plug
Note
When inserting speaker cables into the speaker terminals, insert
only the bare speaker wire. If insulated cable is inserted, the
connection may be poor and sound may not be heard.
CAUTION
Connect the speakers with an impedance as shown below.
If you connect speakers with an excessively low
impedance, this unit may overheat.
Speaker connection
SPEAKERS A or
SPEAKERS B
SPEAKERS A and
SPEAKERS B
Bi-wiring
Speaker impedance
8  or higher
16  or higher
(except for North America model)
8  or higher

■ Bi-wire connection

Bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. With these connections, the mid and
high frequency drivers are connected to one set of terminals
and the low frequency driver to another set of terminals.
This unit
SPEAK
A
B
Connect the other speaker to the other set of terminals in
the same way.
Note
When making bi-wire connections, remove the shorting bridges
or cables on the speaker. Refer to the speakers' instruction
manuals for more information.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B (p. 8) so that both speaker indicators ("SP A" and
"SP B") light up on the front display.
Connections
Speaker
11
En

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

R-n402d

Inhaltsverzeichnis