Mitsubishi Electric GUG-01SL-E Installationsanleitung Seite 4

Safety precautions (continued)
CAUTION
Do not place a burning appliance in a place where it is exposed directly to the air from the
unit.
(It could cause an accident as a result of incomplete combustion.)
Do not use at a place where it is exposed to high temperatures (40˚C or higher), naked
flames, or in environment with combustible fumes.
(It could cause fire.)
Do not use in an environment such as a chemical factory, where hazardous gases such
as acidic gases, alkaline gases, organic solvent fumes, paint fumes, or gases containing
corrosive components are generated.
(It could malfunction.)
Prohibited
Do not install this product in a place where it is exposed to ultraviolet light.
(UV may damage covering insulation.)
Do not connect a commercially available drain pump to the designated drain pipe to drain
water.
(Water may leak due to a drain pump malfunction. This may wet the ceiling, floor, and other
important objects.)
Do not install the end of drain piping immersed in places such as rain gutters.
(At times of heavy snow, rain gutters freeze and drain water is not discharged. This results in
water leaking from the unit.)
Put on gloves during installation.
(It could cause injury.)
Make sure the all-pole isolator is turned off when the unit is not used for a long period of
time after the installation.
(It could cause electric shock, power leakage, or fire as a result of deteriorated insulation.)
Always use the specified suspension bolts, nuts and washers or correctly rated wire /
chain hangers.
(Use of hardware with insufficient strength could result in the product dropping.)
The control box cover must be closed after the installation.
The instructions
(Dust or humidity may cause power leakage or fire.)
given must be
followed.
Securely connect the drain pipes according to the Installation Manual. Ensure water
drainage. Perform insulation work to prevent dew condensation from forming.
(Insufficient piping work causes water leaks. This may wet the ceiling, floor and other household
belongings.)
Insulate the SA side duct, system components and drain pipes.
(Dew condensation forming during air conditioning may cause electrical leakage or damage
household belongings.)
When installing the unit in places such as hospitals or communications service stations,
take necessary measures to shield noise generating sources.
Eng-3