Mitsubishi Electric GUG-01SL-E Installationsanleitung Seite 21

Remote controller (PZ-01RC)
Note
Lossnay remote controller is not described in this section. Please refer
to its installation manual and instruction book.
1. Installation
For the contents below, refer to the appendix of this installation manual.
No. Contents
1 Safety precautions
2 System requirements
3 Component names and supplied parts
4 Field-supplied parts/Required tools
5 Selecting an installation site
6 Installation/Wiring work
7 Important
8 Remote controller button functions
9 Turning on the power
10 Test run
11 Initial settings (Remote controller settings)
12 Service menu
13 Remote controller check
2. Menu list
The table below shows the function menu that can be used.
Main menu
Vane/Louvre/Vent. (Lossnay)
High power
Timer
On/Off timer
Auto-Off timer
Weekly timer
OU silent mode
Restriction
Temp. range
Operation locked
Energy saving
Auto return
Schedule
Filter information
Error information
Maintenance
Auto descending panel
Manual vane angle
Initial setting
Main/Sub
Clock
Main display
Contrast
Display details
Auto mode
Administrator password
Language selection
Service
Test run
Drain pump test run
Input maintenance info.
Function setting
Check
Request code
Other than request code
Self check
Maintenance password
Remote controller check
*1: Two remote controllers cannot be used in a system, so please do
not change from the factory setting.
*2: Auto mode is only available for the RA temperature control.
*3: Setting change is required for the SA temperature control. Please
see the next page.
*4: When PZ-61DR-E is also used, set the timer function from
PZ-61DR-E.
*5: How to use and how to set are the same way as MA remote
controller PAR-31MAA, so please refer to the appendix in the
installation manual and instruction book.
Eng-20
3. Initial setting
(1) For the SA temp. control, set the Room temperature not to be
Note
For the RA temp. control, if the display is necessary please skip this
setting.
Refer to appendix
page 1
page 3
page 3
page 4
page 4
page 5
page 8
page 9
page 10
page 10
page 10
page 13
page 16
Remarks
Not available -
Not available -
Available *4
Available *4
Available *4
Not available -
Available *5
Available *5
Available *5
Not available -
Not available *5
Available *5
Not available -
Not available -
Available *1
Available *5
Available *5
Available *5
Available *3
Available *2
Available *5
Available *5
Available *5
Not available -
Available *5
Available *5
Available *5
Available *5
Not available -
Available *5
Available *5
Available *5
displayed using the following steps.
[Default display]
Room
Cool Set temp.
Mode Temp.
[Step1]
From the Main display, select "Main menu" - > "Initial setting" - >
"Display details".
Initial setting menu
Main/Sub
Clock
Main display
Contrast
Display details
Main menu:
Cursor Page
[Step2]
Move the cursor to the "Room temp." on the display details setting
screen, and select "No" with the F3 or F4 button. (Factory setting
is "Yes".)
Display details
Clock No 24h
Temperature °C / °F / 1°C
Yes / No
Room temp.
Auto mode Yes / No
Select:
Cursor Cursor
[Step3]
Check that "Room temperature" is not displayed.
Set temp.
Cool
Mode Temp.
Fri
1/2
Fri