Manual Override - Gemü 693 Original Einbau- Und Montageanleitung

11.4

Manual override

Trip cam
OPEN limit switch
Roller lever
CAUTION
Trip cam must not travel beyond upper
limit switch with manual override.
Damage to switch mounting plate.
®
Distortion of the spindle guide.
®
Only actuate manual override within the
G
end positions, if necessary remove the
actuator cover to check.
If the actuator is equipped with
a potentiometer, use of the
emergency hand crank may cause
the potentiometer to move out of
adjustment. After performing a
manual override, therefore, reset
the potentiometer as explained
in chapter 11.2 before putting the
actuator back into operation.
If manual override is required, take the
following steps:
1
Switch mounting plate
CLOSED limit switch
Lower spindle guide
Unscrew the transparent cap 1 and pull it
G
out together with the adapter 2. This unit
forms the hand crank 3.
1
Remove the sealing plug 4 on the face.
G
Push the adapter 2 firmly into the
G
opening.
Crank into the desired valve position
G
(direction: as indicated on label) using the
hand crank 3.
47 / 64
3
2
4
2
3
693, 698