Proklima FN-114507.1 Bedienungsanleitung Seite 62

FN-114507.1 & FN-114507.2
PARTS DESCRIPTION
1. Fan guard
2. Fan blade
3. U tube
4. Neck lock
5. Control panel
6. Height adjustment pipe
7. Height adjust knob
8. Standing shaft
9. Standing base
10. Weight support
11. Fastener
12. L screw
13. Remote control
14. Support for cable storage
Control panel and remote control
a. Sleep mode light
b. Nature mode light
c. Normal mode light
d. Timer lights
e. High speed light
f. Mid speed light
g. Low speed light
A. Timer
B. On/speed button
C. Off button
D. Mode button
Note: Please use two AAA batteries for this
remote control.
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
1. Assembly of the stand
Rotate the fastener and the L screw out from the bottom of the standing shaft.

Put the standing shaft into the standing base.

Place the weight support to the bottom of the base. Tighten the weight support to

the base with fastener and the L screw.
2. Fan head assembly
Pull the height adjustment pipe out to your desired height and tighten the height

adjust knob.
Fix the neck lock to the U tube by two screws (a), gaskets and nuts. Pay attention

do not screw tight. Place the fan head, together with the neck lock, onto the top of
height adjustment pipe. Insert the other two screws (b) through the holes of the neck lock and the standing
- 61 -
GB