EN
OCEAN W7
Description of the functions
Cleaning stop and Continuous flow:
DIP switch 3
Cleaning stop: Serves to disable automatic activation prior to cleaning.
Continuous flow: Enable the continuous flow function to fill the washbasin
or a container.
DIP switch 3 "ON"
DIP switch 3 "OFF"
Activate cleaning stop:
Deactivate cleaning stop:
WimTec OCEAN W7
36
Wall fitting
= Cleaning stop and continuous flow function enabled (preset).
= Cleaning stop and continuous flow function disabled.
1.
Position your hand (approx. 4 cm) in front of the infrared
sensor (below the spout) and wait.
2.
The AquaCap sensor button starts flashing.
3.
In the meantime, use your free hand to tap the AquaCap
sensor button and thus enable the cleaning stop.
Automatic:
The device will automatically resume normal operation 3 min
after activation.
Manual:
1.
Position your hand (approx. 4 cm) in front of the infrared
sensor (below the spout) and wait.
2.
The AquaCap sensor button starts flashing.
3.
In the meantime, use your free hand to tap the AquaCap
sensor button and thus disable the cleaning stop. The fitting
then switches on automatically.
ON
OFF
1
2 3 4 5 6