WimTec OCEAN W7 Montage- Und Bedienungsanleitung Seite 31

OCEAN W7
Assembly
13
16
13. Connect the magnetic valve to the electronics module
and attach the earth wire (yellow) to the water path.
14.
Connect the infrared sensor (wide connector) to the
electronics module.
15. Connect the glass front plate (narrow connector) to the
electronics module.
16. Insert the electronics module into the designated slot.
17.
Open both integrated stop valves using a screwdriver.
18. Place the mixing shaft and mixer handle into the central
position – both the dot and knob should point upwards.
14
17
15
18
Perform the following steps
in the order indicated!
WimTec OCEAN W7
Wall fitting
EN
!
ATTENTION!
31